FreedomYachts.org

I have a 39 ph catch schooner and need the dimensions for the sails so I can have them made here in Port Jefferson New York by Jack Wedenkind a very prominent sailmaker I must say .Can someone email the dimensions to him for me please his email adress is wedekindsail@juno.com thanks to all here on this site and God Bless. my cell # is 631 974 5134 feel free to call me at anytime Arthur

Arthur,

There is a Canadian named Yves on this board who posted a diagram with measurements of his sail plan a while ago. If you search the board, you'll find it.

Hello Arthur,

Michel, actually, it's Alain
See attached pdf file for your information. Of course, this is based on my masts dimensions, batten pockets, etc. If you have a single line in-boom reefs, be carefull to where you locate the reefing eyes. The second and third reefs on my new sales can't reach the booms at the mast, because the slides I use (Tides Marine) are "piling up" too high. (if you can't make sense out of this last comment , let me know, I'll reformulate)
Cheers

Alain! My apologies! How could I be so forgetful. Must be the mix-up with Yves-Marie de Tanton. Again my apologies.

Fonz, if your sailmaker can't visit the boat you might want to take measurements based on his/her instructions. Too many chances for mistakes otherwise. I've made note to too many little differences among Freedom boats even when they were built close in sequence. And even if there were a "factory spec" we can't assume that a 20-30 year old boat will still be in it.

George

Mauri Pro Sailing have a lot of rig dimensions listed, there are 2 listed for the Freedom 39
http://www.mauriprosailing.com/techinfo/boatspecs/Rig%20F.htm