Search found 210 matches
- Tue Feb 20, 2018 3:28 pm
- Forum: Engines and Mechanical Systems
- Topic: Steering System access on an F-30
- Replies: 7
- Views: 6513
Re: Steering System access on an F-30
They plywood panel at the aft end of the quarter berth unscrews.
- Sat Feb 03, 2018 8:49 pm
- Forum: Engines and Mechanical Systems
- Topic: Folding Prop
- Replies: 18
- Views: 16081
Re: Folding Prop
Hi Mike - I just went the 1/2 mile down to Heart's Desire and back to measure because your 9' measurement didn't seem right for my F-30. It was time to check on her anyway. The distance between the front of the mast and the tab on top of the gun mount is right at 11 feet. (F-30s vary that much?) I o...
- Fri Feb 02, 2018 12:46 am
- Forum: Engines and Mechanical Systems
- Topic: Folding Prop
- Replies: 18
- Views: 16081
Re: Folding Prop
Hi Mike - I don't race, but I need to move in the light airs we have up here (mostly below 10 knots most of the day. Haarstack sent me the following specs for an F30 Top Reacher before he sold out" FREEDOM 30 (MULL) 155% TRIRADIAL "JIB TOP/CODE 0" REACHER LF = 29.0' LP = 15.24' AREA = 223 sqft CLOTH...
- Sun Jan 14, 2018 6:02 pm
- Forum: Plumbing
- Topic: F30 water tank
- Replies: 14
- Views: 13269
- Sun Jan 14, 2018 5:58 pm
- Forum: Plumbing
- Topic: F30 water tank
- Replies: 14
- Views: 13269
Re: F30 water tank
I've put two of these in the top of my water tank. The original tanks are poly plastic.
- Sat Jan 13, 2018 9:34 pm
- Forum: Plumbing
- Topic: F30 water tank
- Replies: 14
- Views: 13269
Re: F30 water tank
On my Ericson the water tank was under the aft berth under the cockpit. Sloshing was not an issue with the 15 gallon flexible tank, but I was not alone on the ocean in a gale either. (Some people are just nuts!! :) ) I think you might consider two flexible tanks in the existing F-30 tank as an enclo...
- Fri Jan 12, 2018 3:27 pm
- Forum: Plumbing
- Topic: F30 water tank
- Replies: 14
- Views: 13269
Re: F30 water tank
Mike - My boat has about 2" open between the rear of the tanks and the chart table bulkhead. The water fill, vent, outlet and some electrical cables all are routed there. I used a hole saw to make a 4" access at the bottom of the chart table bulkhead to get at the tank connections. Work there is a p...
- Wed Jan 10, 2018 9:13 pm
- Forum: Plumbing
- Topic: F30 water tank
- Replies: 14
- Views: 13269
Re: F30 water tank
Hi Mike - I don't use that settee as a bunk so I've sealed the end off permanently and use the whole cabinet in front of the settee bulkhead for storage. My water tank does not extend beyond the bulkhead on either end of the settee, but it is embedded in expanding foam along the bottom and long side...
- Tue Oct 31, 2017 7:43 pm
- Forum: Rigging and Sails
- Topic: Mast deck ring f30
- Replies: 4
- Views: 4409
- Tue May 09, 2017 10:55 pm
- Forum: Buy/Sell/Trade
- Topic: 1984 F32 Gun Mount hardware
- Replies: 10
- Views: 10645
Re: 1984 F32 Gun Mount hardware
Tapered 16' to 24' 3.5" and 4" diameter carbon fiber spinnaker poles are available.
For example: https://www.fisheriessupply.com/forte-c ... rbon-tubes
For example: https://www.fisheriessupply.com/forte-c ... rbon-tubes