F32 Saloon Table??

Anything that doesn't fit into the other Physical Systems categories
murphy1jj
Posts: 10
Joined: Mon Dec 31, 2018 6:31 am
Location: Wrightsville Beach, NC

Re: F32 Saloon Table??

Post by murphy1jj »

Tom, last pic - this shows the table converted to a berth.

Good luck!
Attachments
Table converted to berth
Table converted to berth
Table 7.jpg (18.9 KiB) Viewed 3151 times
John
ConNora Mae
84 F32 #65
Wrightsville Beach, NC

UBETCHAII
Posts: 9
Joined: Tue Aug 20, 2013 5:52 pm

Re: F32 Saloon Table??

Post by UBETCHAII »

When my wife and i owned the F32 the post was difficult to remove. once i had to remove the entire assembly and have a machine shop separate the base and post. after that i would, when i remembered to do it, squirt a bit of WD 40 around the base and it never seized again. needs to be done at least once a qtr. Enjoy the boat! we sure did.

Grimsby_Alan
Posts: 89
Joined: Wed Oct 26, 2016 12:42 pm

Re: F32 Saloon Table??

Post by Grimsby_Alan »

I finally had to get medieval on mine. I removed the top from it’s mount then unscrewed the base from the floor. I tried WD40 a few times over a few weeks. No luck. Hung the whole thing from a sling and gave it a few whacks with a large mallet. It submitted on about the fifth whack. Once apart I sanded the insides of both mounting plates. Working like a charm now. I will wax the post later when things warm up a bit here.
1984 F32 Hoyt hull #41
Port Dalhousie, Ontario

Grimsby_Alan
Posts: 89
Joined: Wed Oct 26, 2016 12:42 pm

Re: F32 Saloon Table??

Post by Grimsby_Alan »

Also, while I had it apart I also used a buffer wheel to remove the old scuffed finish from the mounting plates and resprayed them.
1984 F32 Hoyt hull #41
Port Dalhousie, Ontario

Post Reply